Shrink chuck 4,5° HSK 100 - 10 - 120Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

For safe clamping of taps in end mill holders according to DIN 1835 B

5 x 58 x 18

The design allows the caliper to be used in normal workshop conditions and is resistant to coolant

made of stainless steel with carbide ball

in wooden box 701

Improves chip evacuation and decreases the risk for chip jamming

DIN 1835 form A+B+E and DIN 6535 form HA+HB+HE (larger than dia

The base is designed with a thermal heat isolation hand grip

- for easy determination of the reference point on CNC and conventional machines

On machining centres without synchronised spindles

- Clamping positions: horizontal

Wherever reduced interference contours are required