Can-Am Maverick X3 Front Sway Bar Links by CT Race WorxDESCRIPTION Built for severe riding and conditions, these links can take more abuse and misalignment than the factory joints. The CT Race Worx link is built from a piece of solid 6061 aluminum and drilled and tapped on both sides for American made chromoly JMX FK rods ends with stainless spacers. All hardware is included. This is a direct bolt on replacement with raw aluminum finish. **NOTE** 2017 18 will use small joints and hardware, 2019 and newer

Engineered tube and R-fin technology for the ultimate in heat rejection

boost will be lower

This results in:

The front of the X3 is what we call a floating front end

00 fee will be charged for inspection

In addition

This therefore warrants optimum wear protection and a long life for your engine

The oil- and water-infused air coats the turbocharger compressor blades

Valve Cover Sealing Washers

Compatible with Smart-Lok

Different helixes with more aggressive or less aggressive angles can adjust the pressure on the belt and shift points

EVP has used TAPP clutches on our all-out drag race Can Am X3 and Polaris XPT vehicles with very high engagement launches without failure