Plastics pipes and fittings. Decohesion test of electrofusion assemblies. Strip-bend test1 Scope This International Standard specifies a strip bend test method for the evaluation of ductility of the fusion joint interface of assemblies of pipe and electrofusion fittings and saddle fittings intended for the conveyance of fluids. It is applicable to polyolefin assemblies. NOTE The aim of the strip bend test method is to provide a quick check in order to have an indication of the ductility of the electrofusion interface.

PD IEC/TS 62627‑09 on passive optical devices is relevant to:

EN 13431 deals with the requirements specific to recoverable packaging which apply to reusable packaging when it is no longer reused and thus becomes waste

The treatment of safety in BS EN 61069-7 is confined to hazards that can be present within the BCS itself

2 and 3 illustrate examples of these

in accordance with appliance instructions or national or local regulations or standards

As a manufacturer of autoclaved aerated concrete

the casing is attached to the mounting points by ferrules

Due to these conditions

BS EN 13587 provides laboratory equipment

Landscape companies

if followed BS 4058

This part of ISO 14253 provides guidelines and defines procedures for assisting the customer and supplier to reach amicable agreements on disputed measurement uncertainty statements regulated in accordance with ISO 14253-1