Milling arbors for screw-in cutters BT 40 - M12 - 127 - LB100Application: For mounting screw in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

For mounting straight-shank tools with lateral flat according to DIN 1835 form B (Weldon)

Slides hardened and grinded

Collets sealed for high pressure cooling 120 bar with IC DIN 6499 B (ISO 15488 B) ER-system

For mounting straight-shank tools according to DIN 1835 form B+E

Plug gauge sizes according to DIN 2245

For holding tool holders with polygonal shank ISO 26623-1

With clamping screw

On machining centres without synchronised spindles

prevents chip clogging

Exchangeable carbide tipped scriber

edge radius 1 mm

For collets KPS-system