Cutter arbors with tenon drive - Dimensions of Morse taper1 Scope This part of ISO 3937 specifies the dimensions of cutter arbors with tenon drive and with Morse tapers. The interchangeability dimensions of the milling cutter bearing on the cutter arbor are in conformity with ISO 2780. The dimensions of the retaining screw used are specified in ISO 2780. Morse tapers are in conformance with ISO 296 and ISO 5413.

Telecontrol refers to the connection of process stations

The electrical definitions in this standard are intended to accommodate higher data rates than are specified in IEC 61162‑1

the new technology (including the integration of data

BS 7194 elaborates on the nominal range of use and variations

these terms appear in technical product documentation

rail (for diesel-electric locomotives and multiple units)

Physical and mechanical characteristics

Restraint bearings are bearings that prevent movements in the horizontal plane

5 as well as modifications to existing sections including significant modification of Annex C and an entirely new Annex 1

Drive systems

21 Classification of the characteristics to be specified

and the ERI reader or ERI writer in or outside the vehicle using symmetric encryption techniques