Shrink chuck 4,5° HSK 100 - 18 - 200Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

wrench and collets

radial load

- mobility allows measuring within machines and fixtures

For the assembly and disassembly of collets KPS-system

Ground internally and externally

5V AA Batteries * 3 ( Do not use low self-discharge battery )

- for easy determination of the reference point on CNC and conventional machines

- IP65 degree of protection

For mounting and drifting taper shanks DIN 228-1 A in toolholders DIN 228-1 B

Metallic sealed collets with cooling channels

clamping depth = 50

4 und 5 mm = h4