Gas Powered Tools Butane Gas Refill 250mL T2451Aerosol can of high quality butane suitable for gas powered soldering irons. 250mL net. Important Note On Butane Gas We recommend the use of high quality Iroda butane gas for use in all Iroda gas powered products. Inferior or lower grade butane may contain a higher level of impurities which will block the internal microscopic filters faster causing intermittent or complete failure. WARNING! Must travel by road, regulations prohibit transport by air

Charging Protection

7 segment displays

Screw Thread Size: PG9

Continuity buzzer

I2C Address: 0x44 (default) -> 0x47 (Reference the table on the back of the board)

Push Switch: Active low momentary push switch connected to pin 7 on the 40-way Raspberry Pi GPIO connector (requires the Pi's onboard pull up resistor to be enabled in software)

It is similar to the Arduino Leonardo board and can be programmed using the Arduino IDE

Night vision distance: 850nm IR ray

Waterproof Rating: IP67

Cranking Rating: 1250Amps at 12VDC (1000A at max 50VDC)

Load Capacitance: 10 to 32pF pr series resonant

Input Current: 24V AC  2