Shrink chuck 4,5° BT 50 - 10 - 200Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

sleeves and tool arbors

In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

Delivered with a built-in screw for shortened taper tools

in wooden box 701

The internal thread provided in the PSK tool holder for

clamping depth 2 mm

clamping depth = 47

130 x 46 x 15

For mounting straight-shank tools in collet chucks DIN 6391

T-nuts 18 mm

Contact surface precision grinded

Hydraulic or manual clamping