Plastics. Determination of fracture toughness (G_IC and K_IC) at moderately high loading rates (1 m/s)1 Scope This document specifies the principles and provides guidelines for determining the fracture toughness of plastics in the crack opening mode (Mode I) by a linear elastic fracture mechanics (LEMF) approach, at load point displacement rates of up to 1 m s. It supplements ISO 13586 so as to extend its applicability to loading rates somewhat higher than is the case in the scope of the latter document. Fracture testing at high loading rates presents

XML response information (for SET actions)

structures and civil engineering works in seismic regions

BS EN 17156 will help you in implementing a broad-spectrum analytical method to improve and facilitate quality control

and where the quantity of interest is the fraction of items that are nonconforming

BS EN 14931 on the performance

To assume that an ISO/TS 22600 (PMAC) compatible architecture or its equivalent will be used for managing security services

BS 5990:1990+A1:1990

The charting techniques outlined may be employed to establish and maintain process control over the charted characteristic

This British Standard specifies general requirements for uncoated high tensile strength steel products

Milk and milk products (or fat coming from milk and milk products) are excluded from the scope of this part of ISO 12966

Paper and pulp industries

this procedure can be used for assessing the roughness profile of other abrasive blast-cleaned substrates