Pulps. Laboratory wet disintegration - Disintegration of mechanical pulps at greater than or equal to 85 °C1 Scope This part of ISO 5263 specifies an apparatus and the procedures for the laboratory wet disintegration of mechanical pulps that exhibit latency. This apparatus and procedure are required for preparation of the test portion in a number of other International Standards dealing with pulps. ISO 5263 3 is applicable to all kind of mechanical pulps (i. e. mechanical, semi chemical and chemi mechanical pulps) exhibiting latency. Mechanical pulps not

BS EN 15636 on shower trays of impact modified extruded acrylic sheets is relevant to:

the test methods specified in a) to c) are applied

Tyres and wheels manufacturers

only to specify the process through which such an architecture or design should be developed

BS EN 16812 is designed for conductive tracks where electrical contact between the measurement electrodes and the conductive track is possible

2 Free fall and free fall repeated tests

This document specifies requirements for wire-reinforced hoses and hose assemblies for underground coal mining applications of nominal sizes 6

— type 1 grinding wheels in accordance with ISO 603‑4:1999 with a diameter not exceeding 310 mm and a thickness not exceeding 55 mm

BS EN 60332-1-1 is an international standard that discusses the test for vertical flame propagation for a single insulated wire or cable for electric and optical fibre cable

They are usually made of semiconductor materials such as silicon

NOTE This differentiation corresponds to the relationship between the two guide diameters of the clamp mounted CR fuel injectors

This European Standard identifies the information required to be marked on freight wagons