End mill holder Weldon SK 50 - 08 - 100Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Measures internal grooves

Only nominal size d can be clamped (applicable up to 120 bar)

SK 30 without coolant exit bores on the end faceDelivery:

Horizontal und vertikal aufspannbar

quantity of inserts:

For the coolant supply through the centre of HSK toolholders

Tensile strength in the core of min

with test certificate

Scale reading by nonius: 3

Automatic On/Off to maximize battery life

- four measuring methode: standard

Wherever reduced interference contours are required