Steel wire for mechanical springs - Oil hardened and tempered wire

This document establishes the general principles and procedures to be followed when machining and notching test specimens from compression-moulded and injection-moulded plastics

BS EN 61290-10-2 specifies a test method that independently detects amplified signal power and amplified spontaneous emission (ASE) power by launching optical pulses into the OFA under test

BS EN 60730-2-6:2008 applies to automatic electrical pressure sensing controls with a minimum gauge pressure rating of –60 kPa and a maximum gauge pressure rating of 4

Changes in BS EN 60068-2-6:2008 include:

EN 50085-2-4

the customer will issue a management specification

BS 5809 specifies safety requirements and associated methods of test for the gas heating equipment of the following types:

including self‑erecting tower cranes other than mobile self-erecting tower cranes (which are covered in BS 7121-3)

Extract flow resistance

PD CEN/TS 17286 also contains routine procedures and specifications that are designed to help the users to evaluate the ongoing performance of an installed sorbent trap monitoring system

Suitable alternative materials are under consideration

BS EN 15283-2  covers the following product performance characteristics: reaction to fire