Shrink chuck 4,5° BT 50 - 05 - 100Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

For mounting straight-shank tools with lateral flat according to DIN 1835 form B (Weldon)

Toolholders suitable for induction-

In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

Low-vibration boring barsWith internal coolingLonger durability of insertsFor longitudinal and plane turningSetting angle: 93°Delivery: without inserts

For the manufacturing of special tools

E1= 28 pieces

d = 40/d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079

Collets sealed with seal for IC DIN 6499 B (ISO 15488 B) ER-system

Precision coolant supply: Improves chip evacuation and decreases the risk for chip jamming

• runout accuracy: = 0

LSCX = Clamping depth

High flexibility: Large holding capacity up to –1 mm