PRL Motorsports High Volume Intake System 2022+ Honda Civic 1.5TPRL Motorsport's 11th Gen Civic 1. 5T High Volume Intake system utilizes a 4" oiled cone filter and 1 piece High Volume MAF housing to allow maximum airflow while delivering proper fuel trims. The HDPE rotomolded air box attaches to the supplied High Volume Inlet Air Duct and utilizes the factory air guide + seal for optimal airflow and heat soak reduction. Custom molded 4 ply silicone with receiving grooves allows for all components to be safely

8 Universal A/D I/O pins

The race car functionality allows for full stud engagement and the open end lets you use extended race wheel studs

This Flywheel uses a replaceable friction so you do not have to buy a whole new flywheel when the part wears

low side drive

The stock eccentric bolts provided by Nissan and Infiniti for small camber/toe adjustments tend to slip under high cornering loads

This air intake is relatively easy to install usually in 90 minutes or less using existing factory mounting points

with configurable trip and resettable fuse parameters

designed to keep proper airflow through the front wheel well

4 bar MAP sensor support (43 psi)

Red Line's GL-5 gear oil has been engineered to provide the highest degree of protection and improvement of your differential efficiency

The Elite 2500 ECU is now paired with the new Nexus Software Programmer (NSP) that brings levels of functionality and user-friendliness never seen before in an engine control package

which is ideal for tuning