Standard Test Method for Evaluation of Aeration Resistance of Engine Oils in Direct-Injected Turbocharged Automotive Diesel Engine

NOTE 1 CEN/TR 13737 contains:

The purpose of PD CEN/TR 16411 is to provide replies to requests for interpretations and clarifications of:

A second objective is to determine if any correlations exist between any of the measured properties of the methods

based on sound experimental practice and scientific principles

Manufacturers and suppliers of pipes and components

BS 6475 specifies a processor system bus interface known as Eurobus A that is one of a family of interfaces for use in modular data acquisition

5 Terms and definitions

This International Standard gives a method of evaluating the condition of decorative and protective metallic and inorganic coated panels or articles which have been exposed to corrosive environments for test or for other purposes

which are intended to be used as the logic subsystem of an electrical/electronic/programmable electronic (E/E/PE) safety-related system

Design of SRP/CS

Who is BS EN 1007-6 - Tensile properties of filaments for

Measurements at higher frequencies are to be made in accordance with IEC 60404-10