Shell mill holder HSK 63 - 16 - 100Application: For mounting milling cutters with transversal groove. Note: d = 40 d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079. SK 30 without coolant exit bores on the end faceDelivery: With drivers, cross head retaining screw and cylinder head retaining screw for cutters with central coolant. For d = 60 only with four fi xation screws according to DIN 912. All holders are made of forged steel

wrench and collets

B4 - 25 x 16 x 30

Ergonomic Handle of Design

Setting angle: 95°

without a tool

Cone and flange hardened and grinded

5V AA Batteries * 3 ( Do not use low self-discharge battery )

Torque range : 20-110 Nm

coolant pipes is screwed to the cylinder head screw integrated in the adapter

- Resolution 0

Automatic switch off

Zero-setting at any position for incremental measurement