Nanotechnologies. Guidance on methods for nano- and microtribology measurements1 Scope This Technical Report establishes techniques for the evaluation of tribological performance of sliding contacts with a lateral size of between a few nanometres (nm) and 10 m, and where the applied load is between 50 N and 100 mN. It describes procedures for undertaking these measurements, and provides guidance on the effect of parameters on test results. It does not cover existing SPM techniques, such as frictional force microscopy and atomic

ISO 22915-21 on verification of stability is applicable to:

What is BS EN 81-1:1998+A3:2009

BS EN 12501-1 is a European standard and a part of the BS EN 12501 series that discusses the general corrosion likelihood in soil for the protection of metallic materials against corrosion

handling and storage of samples prior to analysis and the selection of the analytical parameters appropriate to the sampled system and life stage

BS 7121-2-4 gives recommendations for pre-use checks

A diffuser can be simply described as a channel whose flow area increases in the direction of flow

Clauses that are relevant also apply to the use of patent glazing inside buildings

What is BS EN 4859 about

Note: It is not intended for use by manufacturers or certification bodies

BS EN 50377-6-2 specifies the plug features which consist of two cylindrical full zirconia ferrules and a push-pull coupling mechanism

Telecommunication component manufacturer

The measurement of disturbance power using an absorbing clamp is a method for the determination of the radiated disturbance in the frequency range above 30 MHz This measurement method as described in BS EN 55016-1-3 represents an alternative approach to the measurement of the disturbance field strength on an OATS