Plastics. Thermoplastic polyester/ester and polyether/ester elastomers for moulding and extrusion - Designation system and basis for specification1 Scope This document establishes a system of designation for thermoplastic polyester ester and polyether ester elastomers, which may be used as the basis for specifications. The types of thermoplastic polyester ester and polyether ester elastomer are differentiated from each other by a classification system based on appropriate levels of the designatory properties: a) hardness; b) melting temperature; c) tensile flexural modulus of elasticity; and on

as well as the access to these structures and defines the command set

The nomination of bodies to perform functions related to the creation and use of Test Data Sets

at higher frequencies (cf

BS EN 61131-9 on programmable controllers is useful for:

Why should you use BS 4656-36 - Accuracy of portal type Plano-milling machines

for the following:

sample-size reduction of bulk samples and certificate of sampling

The reasons for defining the ergonomics of the DMI are as follows:

It gives guidance on the following aspects of offshore subsea-system operational practice:

BS EN 15958 provides users with a method for the extraction of water soluble phosphorus in fertilizers

As a manufacturer of building hardware

both of which evaluate the fit of the pin gauge(s) into the guide pinhole(s) of the female-type connector