End mill holder Weldon BT 40 - 06 - 50Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Retaining screw for mounting of face mills arbors

Storage Temperature : -40C~85C

Metallic sealed for mounting straight-shank tools with coolant-through in collet chucks ISO 15488 (ex

Delivered with a built-in screw for shortened taper tools

Coolant nozzles lockable for tools with internal coolant

Warranty card

Delivery with test certificate All holders are made of forged steel

bei Ø 6 – Ø 32 mm = h236

with IC DIN 6499 B (ISO 15488 B)ER-system

The clamping screw is drilled through

Sealing capacity up to 80 bar

clamping depth = 50