Radionuclide imaging devices. Characteristics and conditions - Gamma cameras for planar, wholebody, and SPECT imaging1 Scope This part of IEC 61675 specifies terminology and test methods for describing the characteristics of gamma cameras equipped with parallel hole collimators for planar imaging. Additional tests are specified for those gamma cameras that are capable of planar wholebody imaging (planar wholebody imaging equipment) or single photon emission computed tomography (SPECT). These gamma cameras consist of a gantry, single or multiple detector heads, and a

Tubes having an outside diameter of not more than 108 mm are suitable for soldering

to withstand mould or fungus growth without deterioration

and to the behaviour of the die castings when subjected to continuous stress

IRRADIATION with TEST DEVICE in the RADIATION BEAM

BS 8530 specifies requirements for cast and extruded aluminium rainwater systems for use on buildings

Basis of structural analysis

— day-to-day management of applications (the software) and the related data structures and support of costumer organizations

With the help of BS QC 222000

BS EN 10028-2 is the European standard that specifies requirements for flat products for pressure equipment made of weldable nonalloy and alloy steels with elevated temperature properties as specified

you can enhance flour and semolina grinding and processing machinery’ effectiveness and efficacy

This standard is primarily intended to specify the basic requirements for converters in general and the requirements applicable to line commutated converters for conversion of a

BS EN 2365 provides you with a table on dimensions and masses depending on the diameter code