Shrink chuck 4,5° BT 50 - 08 - 200Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Standard type without safety clutch

High holding forces: increase by a factor of 3 to 5 compared to standard jaws

Extension rod >6mm

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance2

- with 2 connectors Ø 6 mm and Ø 8 mm

From d = 25 on two clamping screws

clamping depth = 47

05mm / 1/128"

Carbide tipped measuring faces

with IC DIN 6499 B (ISO 15488 B)ER-system

alloyed steel

- Absolute/incremental measurement