Sampling procedures for inspection by attributes - Introduction to the BS 6001 (ISO 2859) series of standards for sampling for inspection by attributesBS 6001 0: 2006 is part of the BS 6001 series. It provides a general introduction to acceptance sampling by attributes and provides a brief summary of the attribute sampling schemes and plans used in BS 6001 1, BS 6001 2, BS 6001 3, BS 6001 4 and BS 6001 5, which describe specific types of attribute sampling systems. It also provides guidance on the selection of the appropriate inspection system for use in a particular situation. BS 6001 0: 2006

and composites

NOTE To avoid water penetration in masonry walls special tests adjusted to local climate might be needed

ensuring that work or cleaning operations proceed smoothly and without accidents

environmental performance

• factory-made units of either fixed capacity or variable capacity by any means

This document specifies general delivery conditions for filler metals and fluxes for fusion welding of metallic materials

The BS 5306-1 gives recommendations for hose reels and foam inlets

— door leaves placed on the market as a single unit

• instrument transformers

for specific design verification procedures and for the validation of performance by the intended users

Allows the use of equipment not intended for continuous operation

which is withdrawn BS EN 15885:2018 has been editorially revised